MetalworkingFun Forum › Machinery › Lathes v
Possible problem.

Thread Modes
Possible problem.
Dr Stan Offline
Senior
*****
Posts: 2,324
Threads: 271
Joined: Jun 2014
Location: La Libertad, Philippines
The following 1 user Likes Dr Stan's post:
Hopefuldave (03-10-2020)
#9
12-21-2019, 08:42 PM
(12-21-2019, 07:18 PM)Swarf_Newbie Wrote:  Now I would not think that 10mm silver steel 300mm long would flex that much under the pressure of a dti? but I could be wrong!  Rotfl 

Go back & read my previous post.
Reply
Thanks given by:


Messages In This Thread
Possible problem. - by Swarf_Newbie - 12-20-2019, 08:28 PM
RE: Possible problem. - by unioncreek - 12-20-2019, 09:13 PM
RE: Possible problem. - by TomG - 12-20-2019, 09:30 PM
RE: Possible problem. - by Swarf_Newbie - 12-21-2019, 07:01 PM
RE: Possible problem. - by Highpower - 12-20-2019, 10:07 PM
RE: Possible problem. - by Swarf_Newbie - 12-21-2019, 07:18 PM
RE: Possible problem. - by Dr Stan - 12-21-2019, 08:42 PM
RE: Possible problem. - by Highpower - 12-21-2019, 09:53 PM
RE: Possible problem. - by Swarf_Newbie - 12-22-2019, 04:43 PM
RE: Possible problem. - by Vinny - 12-20-2019, 10:43 PM
RE: Possible problem. - by Dr Stan - 12-21-2019, 12:03 AM
RE: Possible problem. - by Highpower - 12-22-2019, 12:46 PM
RE: Possible problem. - by Dr Stan - 12-22-2019, 01:16 PM
RE: Possible problem. - by TomG - 12-22-2019, 02:05 PM
RE: Possible problem. - by Dr Stan - 12-22-2019, 04:03 PM
RE: Possible problem. - by Swarf_Newbie - 12-24-2019, 12:53 PM
RE: Possible problem. - by Swarf_Newbie - 10-17-2020, 05:19 PM
RE: Possible problem. - by Dr Stan - 10-18-2020, 08:51 AM
RE: Possible problem. - by Swarf_Newbie - 10-19-2020, 09:49 AM
RE: Possible problem. - by Dr Stan - 10-19-2020, 11:58 AM



Users browsing this thread: 3 Guest(s)