|
Possible problem.
|
12-22-2019, 04:03 PM
(12-22-2019, 02:05 PM)TomG Wrote: It looks as though the axis of the chuck/part may not be on axis with the lathe spindle. Remove the chuck and check the mounting surface for dirt or burrs. The face of the chuck should also run true if it is mounted correctly. Good point. A single chip between the spindle nose and the back of the chuck will give you fits when trying to indicate in a part. |
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
Possible problem. - by Swarf_Newbie - 12-20-2019, 08:28 PM
RE: Possible problem. - by unioncreek - 12-20-2019, 09:13 PM
RE: Possible problem. - by TomG - 12-20-2019, 09:30 PM
RE: Possible problem. - by Swarf_Newbie - 12-21-2019, 07:01 PM
RE: Possible problem. - by Highpower - 12-20-2019, 10:07 PM
RE: Possible problem. - by Swarf_Newbie - 12-21-2019, 07:18 PM
RE: Possible problem. - by Dr Stan - 12-21-2019, 08:42 PM
RE: Possible problem. - by Highpower - 12-21-2019, 09:53 PM
RE: Possible problem. - by Swarf_Newbie - 12-22-2019, 04:43 PM
RE: Possible problem. - by Vinny - 12-20-2019, 10:43 PM
RE: Possible problem. - by Dr Stan - 12-21-2019, 12:03 AM
RE: Possible problem. - by Highpower - 12-22-2019, 12:46 PM
RE: Possible problem. - by Dr Stan - 12-22-2019, 01:16 PM
RE: Possible problem. - by TomG - 12-22-2019, 02:05 PM
RE: Possible problem. - by Dr Stan - 12-22-2019, 04:03 PM
RE: Possible problem. - by Swarf_Newbie - 12-24-2019, 12:53 PM
RE: Possible problem. - by Swarf_Newbie - 10-17-2020, 05:19 PM
RE: Possible problem. - by Dr Stan - 10-18-2020, 08:51 AM
RE: Possible problem. - by Swarf_Newbie - 10-19-2020, 09:49 AM
RE: Possible problem. - by Dr Stan - 10-19-2020, 11:58 AM
|
