|
Drill Chuck Tap Handle
|
01-27-2020, 08:31 AM
(12-25-2019, 05:19 PM)Cross Slide Wrote: This was the first time I used boring bars. After learning my boring bars sucked straight out of the package, so I did some grinding they cut not to bad. But I’m happy with how it turned out.That was a big milestone in my learning curve when the part went right from the package to the grinder (files in my case.) I hope it made you feel good, that you are finally "getting there." Your results look good. Thanks for the share. |
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
Drill Chuck Tap Handle - by Cross Slide - 12-25-2019, 05:19 PM
RE: Drill Chuck Tap Handle - by Dr Stan - 12-25-2019, 10:54 PM
RE: Drill Chuck Tap Handle - by Cross Slide - 12-25-2019, 11:28 PM
RE: Drill Chuck Tap Handle - by TomG - 12-26-2019, 10:23 AM
RE: Drill Chuck Tap Handle - by Cross Slide - 12-26-2019, 10:43 AM
RE: Drill Chuck Tap Handle - by rleete - 12-27-2019, 09:48 AM
RE: Drill Chuck Tap Handle - by KarlH - 01-27-2020, 08:31 AM
RE: Drill Chuck Tap Handle - by Highpower - 01-27-2020, 01:38 PM
RE: Drill Chuck Tap Handle - by Vinny - 01-27-2020, 11:18 PM
|
