MetalworkingFun Forum › Machinery › Lathes v
Atlas TH42

Thread Modes
Atlas TH42
impman76 Offline
Freshman
**
Posts: 10
Threads: 2
Joined: Dec 2019
Location: Hailsham
#13
12-31-2019, 01:43 PM
The shaft is not one bit, the gear is separate to the shaft rightly or wrongly, it is pinned at the key way end but nothing was holding the opposite gear and it was just turning inside the bronze Bush, so I have already pinned it the same way as the other side. Works just fine!
Reply
Thanks given by:


Messages In This Thread
Atlas TH42 - by impman76 - 12-28-2019, 12:31 PM
RE: Atlas TH42 - by Highpower - 12-28-2019, 02:38 PM
RE: Atlas TH42 - by EdK - 12-28-2019, 02:46 PM
RE: Atlas TH42 - by impman76 - 12-28-2019, 05:08 PM
RE: Atlas TH42 - by impman76 - 12-30-2019, 05:01 AM
RE: Atlas TH42 - by Highpower - 12-30-2019, 12:08 PM
RE: Atlas TH42 - by impman76 - 12-30-2019, 02:47 PM
RE: Atlas TH42 - by Highpower - 12-30-2019, 03:58 PM
RE: Atlas TH42 - by Dr Stan - 12-30-2019, 07:24 PM
RE: Atlas TH42 - by impman76 - 12-31-2019, 11:26 AM
RE: Atlas TH42 - by Highpower - 12-31-2019, 01:05 PM
RE: Atlas TH42 - by impman76 - 12-31-2019, 01:43 PM
RE: Atlas TH42 - by Highpower - 12-31-2019, 02:41 PM
RE: Atlas TH42 - by impman76 - 12-31-2019, 05:22 PM
RE: Atlas TH42 - by Dr Stan - 01-05-2020, 03:49 PM
RE: Atlas TH42 - by Highpower - 01-05-2020, 08:09 PM



Users browsing this thread: 1 Guest(s)