01-22-2020, 03:00 PM
(01-22-2020, 09:38 AM)Vinny Wrote: How about a tapered endmill?
(01-19-2020, 01:02 PM)Highpower Wrote: Paul, were you able to find any dimensioned drawings for this? Just wondering if you are wanting to duplicate the original breach block dimensions, or are you sizing it to fit modern day replica cartridge case dimensions? I've read that the newer cases with a flat bottom on them are too long to chamber in original breach blocks, as oppose to cases with the dished bottom for the flash hole.
Pricey but could do the job of i can find the correct size
