MetalworkingFun Forum › Machinery › Milling Machines › Mill Tooling v
Counterbores - what are you using?

Thread Modes
Counterbores - what are you using?
Highpower Offline
JAFO
******
Posts: 4,367
Threads: 177
Joined: Feb 2012
Location: Missouri, USA
The following 4 users Like Highpower's post:
TomG (05-06-2020), EdK (05-06-2020), f350ca (05-06-2020), arvidj (05-06-2020)
#10
05-06-2020, 09:26 AM
The metric set I ordered from McMaster showed up. I've never heard of Alvord-Polk before but they look decent. Seem to be ground well. Made in the USA.

   
Willie
Reply
Thanks given by:


Messages In This Thread
Counterbores - what are you using? - by Highpower - 04-30-2020, 10:11 PM
RE: Counterbores - what are you using? - by EdK - 05-01-2020, 01:59 PM
RE: Counterbores - what are you using? - by TomG - 05-01-2020, 04:48 PM
RE: Counterbores - what are you using? - by Vinny - 05-02-2020, 08:32 AM
RE: Counterbores - what are you using? - by Vinny - 05-04-2020, 12:32 AM
RE: Counterbores - what are you using? - by Highpower - 05-06-2020, 09:26 AM
RE: Counterbores - what are you using? - by TomG - 05-06-2020, 10:10 AM
RE: Counterbores - what are you using? - by EdK - 05-06-2020, 11:00 AM
RE: Counterbores - what are you using? - by EdK - 05-06-2020, 12:11 PM
RE: Counterbores - what are you using? - by Vinny - 05-07-2020, 12:15 AM



Users browsing this thread: 1 Guest(s)