Help filling tiny gap
#4
One major consideration for a knife blade will be the heat that you are using and how far into the blade it migrates. If you can keep it off the cutting edge, it shouldn't do too bad.
Mike

If you can't get one, make one.

Hawkeye, proud to be a member of MetalworkingFun Forum since Jan 2013.
Reply
Thanks given by:


Messages In This Thread
Help filling tiny gap - by James Riley - 01-01-2021, 12:03 PM
RE: Help filling tiny gap - by f350ca - 01-01-2021, 05:30 PM
RE: Help filling tiny gap - by Highpower - 01-02-2021, 01:10 PM
RE: Help filling tiny gap - by Dr Stan - 01-01-2021, 06:16 PM
RE: Help filling tiny gap - by Hawkeye - 01-01-2021, 11:38 PM
RE: Help filling tiny gap - by Highpower - 01-02-2021, 01:37 PM
RE: Help filling tiny gap - by Dr Stan - 01-02-2021, 01:37 PM



Users browsing this thread: 1 Guest(s)