Holt Engine (maybe)
#11
Looks like that thing is going to be a brute!
Willie
Reply
Thanks given by:
#12
Very nice. Technically I can figure out where the seam should be based on the screw heads but visually lot harder to see. 
Very good work.

Harold
Reply
Thanks given by:
#13
Thanks Harold,
I added two 1/8 dowel pins to locate the halves, The sides were machined after assembly, but the ends mated up after machining each piece.
Free advice is worth exactly what you payed for it.
Greg
Reply
Thanks given by:
#14
(02-13-2021, 08:28 AM)haroldmulder Wrote: Very nice. Technically I can figure out where the seam should be based on the screw heads but visually lot harder to see. 
Very good work.

Harold

I agree. At first glance it all appeared to be a single block (no pun intended) of aluminum until I noticed the screw heads. That is quite a fit!
Willie
Reply
Thanks given by: f350ca




Users browsing this thread: 1 Guest(s)