05-21-2012, 10:39 PM
(This post was last modified: 05-21-2012, 10:42 PM by henryarnold.)
I bought a 6" Rotary Table that is similar to a Phase II. I've used it for many projects but needed something bigger.
So I added a 14" x 3/4" aluminum plate. The plate is registered by a pin in the middle that fits into the MT hole of the table and bolts to the rotary table's T slots with recessed cap screws.
The plate was machined on the rotary table. I used the rotary table to machine the outside edge and all of the mounting holes. Now I can create any round or arced object up to 7" radius.
So I added a 14" x 3/4" aluminum plate. The plate is registered by a pin in the middle that fits into the MT hole of the table and bolts to the rotary table's T slots with recessed cap screws.
The plate was machined on the rotary table. I used the rotary table to machine the outside edge and all of the mounting holes. Now I can create any round or arced object up to 7" radius.
henryarnold, proud to be a member of MetalworkingFun Forum since Apr 2012.