Tooling question for RF-45 clone
#12
Just remember that you can attach a plate like Henry did to his 6" to an 8" rotary table also thus increasing its capacity. This is another one of those tools where I think bigger is better, within reason. Here I go again with my Smiley-gen163

Ed
Reply
Thanks given by:


Messages In This Thread
Tooling question for RF-45 clone - by DanH - 05-21-2012, 04:20 PM
RE: Tooling question for RF-45 clone - by EdK - 05-21-2012, 06:18 PM
RE: Tooling question for RF-45 clone - by krv3000 - 05-21-2012, 06:19 PM
RE: Tooling question for RF-45 clone - by ETC57 - 05-21-2012, 07:11 PM
RE: Tooling question for RF-45 clone - by DanH - 05-22-2012, 11:00 AM
RE: Tooling question for RF-45 clone - by EdK - 05-22-2012, 11:34 AM
RE: Tooling question for RF-45 clone - by DanH - 05-22-2012, 12:14 PM
RE: Tooling question for RF-45 clone - by EdK - 05-22-2012, 04:38 PM
RE: Tooling question for RF-45 clone - by DanH - 05-22-2012, 04:49 PM
RE: Tooling question for RF-45 clone - by EdK - 05-22-2012, 05:09 PM
RE: Tooling question for RF-45 clone - by DanH - 05-22-2012, 06:12 PM
RE: Tooling question for RF-45 clone - by EdK - 05-22-2012, 07:20 PM
RE: Tooling question for RF-45 clone - by EdK - 05-23-2012, 08:05 AM
RE: Tooling question for RF-45 clone - by stevec - 05-23-2012, 08:03 AM
RE: Tooling question for RF-45 clone - by EdK - 05-24-2012, 07:07 AM
RE: Tooling question for RF-45 clone - by stevec - 05-24-2012, 06:31 AM
RE: Tooling question for RF-45 clone - by Mayhem - 05-25-2012, 01:11 AM
RE: Tooling question for RF-45 clone - by DanH - 05-25-2012, 10:15 AM
RE: Tooling question for RF-45 clone - by ETC57 - 05-25-2012, 11:06 AM



Users browsing this thread: 3 Guest(s)