Little Machine Shop Drill Press
#18
(06-10-2021, 08:09 PM)EdK Wrote: It's about 30" long and 70mm in diameter. I may see if I can find some 70mm tubing with a thicker wall on eBay. The base is made of cast iron so it's OK as is.

Ed

Yikes. I just looked at a piece of 2-3/4 DOM steel tubing with a 1/4" wall thickness 36 inches long. $88.00 plus shipping from Speedy Metals.
Is your current column steel or C.I.?
Willie
Reply
Thanks given by:


Messages In This Thread
Little Machine Shop Drill Press - by EdK - 06-09-2021, 04:00 PM
RE: Little Machine Shop Drill Press - by EdK - 06-10-2021, 12:14 AM
RE: Little Machine Shop Drill Press - by rleete - 06-10-2021, 05:59 AM
RE: Little Machine Shop Drill Press - by EdK - 06-10-2021, 12:24 PM
RE: Little Machine Shop Drill Press - by Pete O - 06-10-2021, 08:01 AM
RE: Little Machine Shop Drill Press - by EdK - 06-10-2021, 12:27 PM
RE: Little Machine Shop Drill Press - by Vinny - 06-10-2021, 05:13 PM
RE: Little Machine Shop Drill Press - by EdK - 06-10-2021, 06:46 PM
RE: Little Machine Shop Drill Press - by Vinny - 06-10-2021, 06:58 PM
RE: Little Machine Shop Drill Press - by EdK - 06-10-2021, 07:05 PM
RE: Little Machine Shop Drill Press - by EdK - 06-10-2021, 08:09 PM
RE: Little Machine Shop Drill Press - by Highpower - 06-10-2021, 08:35 PM
RE: Little Machine Shop Drill Press - by EdK - 06-10-2021, 09:30 PM
RE: Little Machine Shop Drill Press - by Vinny - 06-11-2021, 02:59 PM
RE: Little Machine Shop Drill Press - by EdK - 06-10-2021, 08:15 PM
RE: Little Machine Shop Drill Press - by EdK - 06-10-2021, 09:32 PM
RE: Little Machine Shop Drill Press - by EdK - 06-10-2021, 09:36 PM
RE: Little Machine Shop Drill Press - by EdK - 06-11-2021, 10:39 AM
RE: Little Machine Shop Drill Press - by EdK - 06-11-2021, 12:46 PM
RE: Little Machine Shop Drill Press - by EdK - 06-11-2021, 07:28 PM
RE: Little Machine Shop Drill Press - by EdK - 06-12-2021, 12:16 PM
RE: Little Machine Shop Drill Press - by EdK - 07-04-2021, 03:00 PM
RE: Little Machine Shop Drill Press - by EdK - 07-04-2021, 10:30 PM
RE: Little Machine Shop Drill Press - by EdK - 08-25-2021, 01:41 PM
RE: Little Machine Shop Drill Press - by EdK - 08-25-2021, 06:14 PM



Users browsing this thread: 2 Guest(s)