Pulley Puller Adapter
#6
(07-17-2021, 02:38 AM)Highpower Wrote:
(07-16-2021, 08:30 PM)EdK Wrote: I had set it to 29.5 degrees but to the incorrect reference. I got bit by this same error when I first turned threads on my 14x40 lathe.

Ed

Smiley-signs009

I ended up putting a new punch mark on my compound 90° away from the factory line to become the 'correct' zero point.  Slaphead

I'm going to fine tune the angle and scribe a line on the cross slide to mark the proper angle. I did the same thing on my 14x40 lathe but being an old fart, I totally forgot about my past errors. Blush

Ed
Reply
Thanks given by:


Messages In This Thread
Pulley Puller Adapter - by EdK - 07-14-2021, 12:04 AM
RE: Pulley Puller Adapter - by EdK - 07-14-2021, 03:49 PM
RE: Pulley Puller Adapter - by Pete O - 07-14-2021, 09:19 PM
RE: Pulley Puller Adapter - by EdK - 07-16-2021, 08:30 PM
RE: Pulley Puller Adapter - by Highpower - 07-17-2021, 02:38 AM
RE: Pulley Puller Adapter - by EdK - 07-17-2021, 02:48 AM
RE: Pulley Puller Adapter - by Highpower - 07-17-2021, 01:02 PM
RE: Pulley Puller Adapter - by EdK - 07-19-2021, 10:11 AM
RE: Pulley Puller Adapter - by rleete - 07-19-2021, 11:09 AM
RE: Pulley Puller Adapter - by EdK - 07-19-2021, 12:27 PM
RE: Pulley Puller Adapter - by Dr Stan - 07-22-2021, 09:34 AM



Users browsing this thread: 1 Guest(s)