Rebuilding TheMac #445 spindle
#1
Hi everyone.
I need to replace the bearings in my TheMac J40 #445 spindle, it sounded like it had marbles in it, when I used it the other day. Yes I oiled it with Mobil light spindle oil before turning it buy hand before powering it up. It is an older model J40 I bought about 15 yrs ago. Any help like bearing numbers, suggestions on reassembly, what to use to clean the gunk from inside, can I reuse the the oil pads inside the spindle. There are no numbers on the the bearings. So I need to find replacements.the RPMs on the side of the spindle is stamp is 9300 RPM. Any help will be greatly appreciated.
CH Thumbsup
Reply
Thanks given by:
#2
Hello CH. Welcome to the forum. Welcome

My suggestion would be to email the company with your questions to get the best answer(s).

https://themacgrinders.com/pages/j-40-parts
Willie
Reply
Thanks given by:




Users browsing this thread: 1 Guest(s)