Powered Drill Press Table
#7
(01-17-2022, 09:34 AM)rleete Wrote:
(01-16-2022, 04:54 PM)Pete O Wrote: Nice job. I have a couple of linear actuators looking for something to actuate, this is now on the list of possibilities. Are you still able to rotate the table left / right?

Yes, there is enough slop in the mounting points that I can swing it about 30 degrees either way.  But, to be honest, I rarely do that.

For the guys needing to swing the table, a column clamp would be the way to go so you can swing it around
Reply
Thanks given by:


Messages In This Thread
Powered Drill Press Table - by rleete - 01-16-2022, 02:44 PM
RE: Powered Drill Press Table - by Pete O - 01-16-2022, 04:54 PM
RE: Powered Drill Press Table - by rleete - 01-17-2022, 09:34 AM
RE: Powered Drill Press Table - by Dave J - 01-21-2022, 06:38 AM
RE: Powered Drill Press Table - by Highpower - 01-16-2022, 05:50 PM
RE: Powered Drill Press Table - by Hawkeye - 01-16-2022, 11:39 PM
RE: Powered Drill Press Table - by Highpower - 01-17-2022, 10:07 AM
RE: Powered Drill Press Table - by rleete - 01-21-2022, 08:29 AM



Users browsing this thread: 1 Guest(s)