Lathe chuck advice
#3
People use 5" chucks on these lathes all of the time. For hobby purposes I doubt it would be an issue. I wanted a 5" 4-jaw chuck but LMS didn't have any in stock and I needed a 4-jaw chuck for a project i was working so I got the 4". I also got a 4" 3-jaw chuck shortly after I bought the lathe. I had an issue with the 3-jaw chuck and LMS replaced it and paid to ship back the defective one. Good customer service. I assume Amazon would also allow returns.  Smiley-gen163

Ed
Reply
Thanks given by:


Messages In This Thread
Lathe chuck advice - by rleete - 03-10-2023, 09:10 AM
RE: Lathe chuck advice - by Dr Stan - 03-11-2023, 11:29 PM
RE: Lathe chuck advice - by EdK - 03-12-2023, 11:57 AM
RE: Lathe chuck advice - by rleete - 03-12-2023, 01:16 PM
RE: Lathe chuck advice - by Vinny - 03-12-2023, 07:04 PM
RE: Lathe chuck advice - by EdK - 03-13-2023, 11:28 AM
RE: Lathe chuck advice - by rleete - 04-01-2023, 02:45 PM



Users browsing this thread: 2 Guest(s)