Lathe chuck advice
#6
There are other advantages to the 5" chuck. The center hole is larger so you can get larger parts into the chuck to reduce stick-out. May not be worth the extra cost if you don't need that advantage.  Smiley-gen163

Ed
Reply
Thanks given by:


Messages In This Thread
Lathe chuck advice - by rleete - 03-10-2023, 09:10 AM
RE: Lathe chuck advice - by Dr Stan - 03-11-2023, 11:29 PM
RE: Lathe chuck advice - by EdK - 03-12-2023, 11:57 AM
RE: Lathe chuck advice - by rleete - 03-12-2023, 01:16 PM
RE: Lathe chuck advice - by Vinny - 03-12-2023, 07:04 PM
RE: Lathe chuck advice - by EdK - 03-13-2023, 11:28 AM
RE: Lathe chuck advice - by rleete - 04-01-2023, 02:45 PM



Users browsing this thread: 1 Guest(s)