MetalworkingFun Forum › Machining › Projects v
Motor control box

Thread Modes
Motor control box
Hopefuldave Offline
Sophmore
***
Posts: 168
Threads: 6
Joined: Mar 2012
Location: Surrey, England
#11
06-13-2012, 04:43 PM
Nice neat job, mate - I wish I had 3-phase, looks so much simpler than all the gubbins I had to put together for the VFD conversion on my lathe (I did go a bit over the top, though...)

I see you went with the patriotic wiring for Her Maj's jubilee, too Big Grin

Dave H. (the other one)
Rules are for the obedience of fools, and the guidance of wise men...
(Douglas Bader)
Reply
Thanks given by:


Messages In This Thread
Motor control box - by Mayhem - 06-09-2012, 10:58 PM
RE: Motor control box - by doubleboost - 06-10-2012, 06:50 AM
RE: Motor control box - by Highpower - 06-10-2012, 07:40 AM
RE: Motor control box - by DaveH - 06-10-2012, 08:59 AM
RE: Motor control box - by stevec - 06-10-2012, 06:53 AM
RE: Motor control box - by krv3000 - 06-10-2012, 04:32 PM
RE: Motor control box - by EdK - 06-10-2012, 05:42 PM
RE: Motor control box - by Mayhem - 06-10-2012, 08:17 PM
RE: Motor control box - by Rickabilly - 06-11-2012, 08:04 AM
RE: Motor control box - by stevec - 06-11-2012, 03:43 PM
RE: Motor control box - by Hopefuldave - 06-13-2012, 04:43 PM
RE: Motor control box - by Rickabilly - 06-14-2012, 06:41 AM
RE: Motor control box - by stevec - 06-14-2012, 06:52 AM
RE: Motor control box - by Rickabilly - 06-14-2012, 08:59 AM
RE: Motor control box - by Mayhem - 06-13-2012, 05:37 PM
RE: Motor control box - by Tony Wells - 06-14-2012, 07:17 AM
RE: Motor control box - by Mayhem - 06-14-2012, 09:51 AM
RE: Motor control box - by Rickabilly - 06-14-2012, 10:02 AM
RE: Motor control box - by Mayhem - 06-14-2012, 10:11 AM
RE: Motor control box - by Hopefuldave - 06-14-2012, 01:23 PM
RE: Motor control box - by Rickabilly - 06-14-2012, 01:42 PM



Users browsing this thread: 1 Guest(s)