MetalworkingFun Forum › Machining › General Metalworking Discussion v
Floor mats

Thread Modes
Floor mats
EdK Offline
Whipping Boy
*******
Posts: 8,749
Threads: 314
Joined: Feb 2012
Location: Arizona/Minnesota
#7
06-14-2012, 06:45 PM
(06-14-2012, 06:26 PM)stevec Wrote: I'm gonna look into that Ed. How do you think the lazy boy's casters will handle that?

Steve,

The Lazy Boy casters would probably not be good for that matting. Change to some larger diameter casters and you should be good to go. Big Grin

Ed
Reply
Thanks given by:


Messages In This Thread
Floor mats - by DanH - 06-14-2012, 12:39 PM
RE: Floor mats - by rleete - 06-14-2012, 01:20 PM
RE: Floor mats - by stevec - 06-14-2012, 03:54 PM
RE: Floor mats - by EdK - 06-14-2012, 05:38 PM
RE: Floor mats - by henryarnold - 06-14-2012, 10:49 PM
RE: Floor mats - by EdK - 06-15-2012, 04:55 PM
RE: Floor mats - by stevec - 06-14-2012, 06:26 PM
RE: Floor mats - by EdK - 06-14-2012, 06:45 PM
RE: Floor mats - by tlfamm - 06-14-2012, 06:33 PM
RE: Floor mats - by big job - 06-15-2012, 04:40 AM
RE: Floor mats - by mikecwik - 06-16-2012, 07:03 PM
RE: Floor mats - by lemelman - 07-18-2012, 02:02 AM
RE: Floor mats - by doubleboost - 07-18-2012, 04:18 PM
RE: Floor mats - by krv3000 - 07-18-2012, 06:38 PM
RE: Floor mats - by Mayhem - 07-18-2012, 08:56 PM
RE: Floor mats - by TomG - 07-19-2012, 07:53 PM
RE: Floor mats - by Mayhem - 07-19-2012, 09:14 PM
RE: Floor mats - by ETC57 - 07-19-2012, 10:05 PM



Users browsing this thread: 1 Guest(s)