MetalworkingFun Forum › Machining › General Metalworking Discussion v
Floor mats

Thread Modes
Floor mats
lemelman Offline
Freshman
**
Posts: 11
Threads: 1
Joined: Jul 2012
Location: Warwickshire, UK
#12
07-18-2012, 02:02 AM
I gave up on using any form of matting. With soft matting the swarf just got embedded in it and was very difficult to remove, and with hard matting the swarf lay on top and stuck to my shoes..
I made some wooden duck-boards instead, they're comfortable to stand on, and the swarf just drops through.


Attached Files Thumbnail(s)
   
lemelman, proud to be a member of MetalworkingFun since Jul 2012.
Reply
Thanks given by:


Messages In This Thread
Floor mats - by DanH - 06-14-2012, 12:39 PM
RE: Floor mats - by rleete - 06-14-2012, 01:20 PM
RE: Floor mats - by stevec - 06-14-2012, 03:54 PM
RE: Floor mats - by EdK - 06-14-2012, 05:38 PM
RE: Floor mats - by henryarnold - 06-14-2012, 10:49 PM
RE: Floor mats - by EdK - 06-15-2012, 04:55 PM
RE: Floor mats - by stevec - 06-14-2012, 06:26 PM
RE: Floor mats - by EdK - 06-14-2012, 06:45 PM
RE: Floor mats - by tlfamm - 06-14-2012, 06:33 PM
RE: Floor mats - by big job - 06-15-2012, 04:40 AM
RE: Floor mats - by mikecwik - 06-16-2012, 07:03 PM
RE: Floor mats - by lemelman - 07-18-2012, 02:02 AM
RE: Floor mats - by doubleboost - 07-18-2012, 04:18 PM
RE: Floor mats - by krv3000 - 07-18-2012, 06:38 PM
RE: Floor mats - by Mayhem - 07-18-2012, 08:56 PM
RE: Floor mats - by TomG - 07-19-2012, 07:53 PM
RE: Floor mats - by Mayhem - 07-19-2012, 09:14 PM
RE: Floor mats - by ETC57 - 07-19-2012, 10:05 PM



Users browsing this thread: