change wheel locks
#1
hi i had to mack thees up they for making changing the gears easy i made two washers for the square witch is 13mm and two for the shaft Clarence witch is 10mm with a 1mm step on the back i cut threw the edge of the 13mm one then filed square did the same to the 10mm one but left it round then silver soldered the two together right pics


Attached Files Thumbnail(s)
                   
krv3000, proud to be a member of MetalworkingFun Forum since Feb 2012.
Reply
Thanks given by:
#2
Nicely made Bob ThumbsupThumbsupThumbsup
Smiley-eatdrink004
DaveH
Reply
Thanks given by:
#3
Good job Bob. You never cease to amaze me.

Ron
ozzie46, proud to be a member of Metalworking Forum since Mar 2012.
Reply
Thanks given by:
#4
thanks ron and dave
krv3000, proud to be a member of MetalworkingFun Forum since Feb 2012.
Reply
Thanks given by:




Users browsing this thread: 1 Guest(s)