1st Engine: PM Research 2A engine
#1
Hi Guys!

I finally finished my first project!
A PM Research 2A wobbler.
Not too bad for a first project and it only took me a week to do it!

I did not take any during pictures...
It is simple and enough have been built!
I still need to disassemble it and paint it but that will be done when time permits.

The good news it... IT RUNS!!!!!Smiley-dancenana

Anyway here is a very short clip taken with my iphone.
Once it is complete i will do a better one!

http://youtu.be/ShCiVHDcxD0

Andrew
A proud member of MetalworkingFun Forum since Feb 2012.

1959 Myford ML7,1949 South Bend 9A,Clausing 8520 mill,Keller Die filer,1929 Rhodes Shaper.
Reply
Thanks given by:
#2
Andrew,

That sounds like it's running very nicely. Nice job. Thumbsup

Ed
Reply
Thanks given by:
#3
Way cool, I like it Andrew.

"Billy G"
Reply
Thanks given by:
#4
Andrew,

Very nice Smiley-signs107

Smiley-eatdrink004
DaveH
Reply
Thanks given by:
#5
Andrew,

Very nice
Great to see a fly wheel with no wobble
John
Reply
Thanks given by:
#6
hi and a good job well dun
krv3000, proud to be a member of MetalworkingFun Forum since Feb 2012.
Reply
Thanks given by:
#7
Good job Andrew. It looks to be a nice smooth running engine.

Congrats on your first! Smiley-signs107

Tom
[Image: TomsTechLogo-Profile.png]
Reply
Thanks given by:
#8
Looks great Andrew,Smiley-signs107

Jerry.Popcorn
ETC57, proud to be a member of MetalworkingFun Forum since Feb 2012.
Reply
Thanks given by:




Users browsing this thread: 1 Guest(s)