How to Square Up Stock on the Milling Machine
#11
(06-23-2012, 04:42 PM)TomG Wrote: I like to set the dial to whatever I have to take off so I don't forget the number, but that's just me.

Tom

That's a good tip Tom. Much like setting a lathe cross slide when threading. You always know to return to "zero". Smiley-eatdrink004
Willie
Reply
Thanks given by:


Messages In This Thread
RE: How to Square Up Stock on the Milling Machine - by November X-ray - 06-23-2012, 08:14 AM
RE: How to Square Up Stock on the Milling Machine - by Highpower - 06-23-2012, 05:33 PM



Users browsing this thread: 3 Guest(s)