Quest -- A Good Steady Rest
#21
a job well dun
krv3000, proud to be a member of MetalworkingFun Forum since Feb 2012.
Reply
Thanks given by:
#22
Great work, Gruby.
Busy Bee 12-36 lathe, Busy Bee Mill drill, Busy Bee 4x6 bandsaw, Homemade 9x17 bandsaw, Ad infinitum.
Reply
Thanks given by:
#23
Thank you. You guys ain't seen nuthin yer. Wait till you see the makeshift counterbore.

"Billy G"
Reply
Thanks given by:
#24
The brains of the assembly are parts E&G. They are held together with loctite. This assembly is fitted into the cap, the flange is in a counterbore. This assembly fits over the tube. The Nylon washer keeps it from binding. The cap is held on by 3 set screws. Now you have a unit that will turn in place. The bearing holder now screws to that. By turning the knob either way the holder moves in and out of the tube. Flats on the holder and the lock screws keep the holder fron rotating. Any questions yet? That little Horizontal Mill is a Ames. It has done a lot of work for me. Owned by a good buddy in the gear business.

"Billy G" Chin


Attached Files Thumbnail(s)
                                       
Reply
Thanks given by:
#25
Now we have to fit the tubes to the ring. See you in a bit. Since I have no mill I need my drill press ans a fixture. Wood to the rescue yet one more time. LOL

"Billy G" Thumbsup


Attached Files Thumbnail(s)
       
Reply
Thanks given by:
#26
Let's drill and ream some hole,3 required 120 degrees apart. #1 locked to XY Table. #2 Position 1 Drill. #3 Position 2 Drill. There is a third. #4,#5 Adjustable reamer to +.005 of .625. #6 Fit is dead nuts.

Billy G"


Attached Files Thumbnail(s)
                       
Reply
Thanks given by:
#27
Now we counterbore those holes. I had a .875 Counterbore but no .625 pilot. I turned a piece of 5/16-18 all thread and press fit it to the C/bore. I then threaded the bearing holder onto it violla c/bore and pilot. C/bores are .250 deep to locate the tubes.

"Billy G" Thumbsup


Attached Files Thumbnail(s)
               
Reply
Thanks given by:
#28
One more hole was needed on the ring ID for the single Clamp Screw. Next we will fit it all together (Ring, Base, and Tubes) and send it off to the welder.

"Billy G" Rotfl


Attached Files Thumbnail(s)
   
Reply
Thanks given by:
#29
Back from the welder AOK.

"Billy G"


Attached Files Thumbnail(s)
   
Reply
Thanks given by:
#30
Bill

Looking very good
WorthyWorthy


Some very clever work going on there67996799

Great pictures
John
Reply
Thanks given by:




Users browsing this thread: 2 Guest(s)