Machining an AR15 lower receiver
#38
This is the kind of thing that makes me sad though. Bad internet advice. This poor guy was convinced by someone else on another forum that he could successfully do this kind of work with nothing more than a bench top drill press and a Dremel tool. Bash

[Image: 1229112009.jpg]

[Image: 1230111904.jpg]

[Image: 100_1456.jpg]

[Image: 100_1458.jpg]
Willie
Reply
Thanks given by:


Messages In This Thread
Machining an AR15 lower receiver - by Highpower - 06-20-2012, 04:35 PM
RE: Machining an AR15 lower receiver - by EdK - 06-20-2012, 04:47 PM
RE: Machining an AR15 lower receiver - by EdK - 06-20-2012, 05:03 PM
RE: Machining an AR15 lower receiver - by EdK - 06-20-2012, 04:55 PM
RE: Machining an AR15 lower receiver - by stevec - 12-01-2013, 07:28 AM
RE: Machining an AR15 lower receiver - by TomG - 06-20-2012, 05:10 PM
RE: Machining an AR15 lower receiver - by TomG - 06-20-2012, 05:41 PM
RE: Machining an AR15 lower receiver - by ETC57 - 06-20-2012, 06:12 PM
RE: Machining an AR15 lower receiver - by RobWilson - 06-21-2012, 09:12 AM
RE: Machining an AR15 lower receiver - by TomG - 06-21-2012, 01:49 PM
RE: Machining an AR15 lower receiver - by TomG - 06-21-2012, 04:33 PM
RE: Machining an AR15 lower receiver - by DaveH - 06-21-2012, 03:26 PM
RE: Machining an AR15 lower receiver - by RobWilson - 06-22-2012, 10:51 AM
RE: Machining an AR15 lower receiver - by TomG - 06-21-2012, 10:17 PM
RE: Machining an AR15 lower receiver - by Mayhem - 06-21-2012, 10:30 PM
RE: Machining an AR15 lower receiver - by TomG - 06-22-2012, 06:28 AM
RE: Machining an AR15 lower receiver - by DaveH - 06-22-2012, 09:25 AM
RE: Machining an AR15 lower receiver - by Highpower - 06-29-2012, 08:31 PM
RE: Machining an AR15 lower receiver - by DaveH - 06-29-2012, 08:38 PM
RE: Machining an AR15 lower receiver - by TomG - 06-29-2012, 08:46 PM
RE: Machining an AR15 lower receiver - by d65 - 11-30-2013, 09:49 PM



Users browsing this thread: 2 Guest(s)