MetalworkingFun Forum › Machinery › Other Machinery › Shapers v
Elliott 10m Shaper

Thread Modes
Elliott 10m Shaper
doubleboost Offline
Super Moderator
******
Posts: 1,459
Threads: 159
Joined: Feb 2012
Location: Northern England
#2
06-25-2012, 04:05 PM
Hi
Andy
If the motor is duel voltage
220 440 you will be able to run it of a VFD inverter 220 volt
Otherwise it will need a phase converter 440 volt
If it was me i would change the motor for a single phase unit
John
http://www.youtube.com/user/doubleboost
Reply
Thanks given by:


Messages In This Thread
Elliott 10m Shaper - by b4dyc - 06-25-2012, 03:48 PM
RE: Elliott 10m Shaper - by doubleboost - 06-25-2012, 04:05 PM
RE: Elliott 10m Shaper - by stevec - 06-25-2012, 04:13 PM
RE: Elliott 10m Shaper - by b4dyc - 06-26-2012, 06:50 AM
RE: Elliott 10m Shaper - by stevec - 06-28-2012, 01:27 PM
RE: Elliott 10m Shaper - by doubleboost - 06-26-2012, 10:46 AM
RE: Elliott 10m Shaper - by krv3000 - 06-26-2012, 03:02 PM
RE: Elliott 10m Shaper - by Hopefuldave - 06-28-2012, 12:53 PM
RE: Elliott 10m Shaper - by b4dyc - 06-28-2012, 04:19 PM
RE: Elliott 10m Shaper - by Hopefuldave - 06-29-2012, 02:37 AM



Users browsing this thread: 1 Guest(s)