06-26-2012, 06:50 AM
hi
I don`t know if its dual voltage, where would I find that out?
It does say 950 RPM on the motor for sure.
I was hoping for a simple solution although I do have a couple of 3/4 HP 240 volt motors lying around. I`m guessing that the cost of a new belt and a new pulley will put the cost near to a converter? Although I do not know...
As it is, it would make a top class anchor
I don`t know if its dual voltage, where would I find that out?
It does say 950 RPM on the motor for sure.
I was hoping for a simple solution although I do have a couple of 3/4 HP 240 volt motors lying around. I`m guessing that the cost of a new belt and a new pulley will put the cost near to a converter? Although I do not know...
As it is, it would make a top class anchor
Andy 
b4dyc, proud to be a member of MetalworkingFun Forum since Apr 2012. Oh yeah
b4dyc, proud to be a member of MetalworkingFun Forum since Apr 2012. Oh yeah