P&W 1830 Radial in 1/6 scale.
Bill,

That's aluminum, correct?

Thanks,
Ed
Reply
Thanks given by:
Yes Ed, 7075.

"Billy G"
Reply
Thanks given by: EdK
OK -- Almost ready for the mill. The centering of the rear crankcase to the rotary table is being done here. This can become a real PITA. When that happens, the "Golden Rule" should take care of it. That is WALK AWAY.

"Billy G"


Attached Files Thumbnail(s)
   
Reply
Thanks given by:
Did the set-up work, you tell me. 9 flats on the rear case, start to finish.

"Billy G"


Attached Files Thumbnail(s)
               
Reply
Thanks given by:
Looking good!


Bill, any particular reason you used 7075 as opposed to 6061?
I have 6061 on hand for my Edwards Five.

Ron
ozzie46, proud to be a member of Metalworking Forum since Mar 2012.
Reply
Thanks given by:
Because of the size of this beast (16+ HP/9500 RPM) 6061 was not considered strong enough. It will do for yours.

"Billy G"
Reply
Thanks given by: ozzie46
VROOOOOOOOM!!!!!! I like itSmiley-signs107
Looking good BillSmiley-eatdrink004
Jerry Popcorn
ETC57, proud to be a member of MetalworkingFun Forum since Feb 2012.
Reply
Thanks given by:
(03-20-2013, 07:41 PM)Bill Gruby Wrote: Because of the size of this beast (16+ HP/9500 RPM) 6061 was not considered strong enough. It will do for yours.

"Billy G"


Thanks Bill

Ron
ozzie46, proud to be a member of Metalworking Forum since Mar 2012.
Reply
Thanks given by:
Plunge cut pilot holes (11/16). Early start today.

"Billy G"


Attached Files Thumbnail(s)
   
Reply
Thanks given by:
Looking good Bill.
Hunting American dentists since 2015.
Reply
Thanks given by:




Users browsing this thread: 2 Guest(s)