P&W 1830 Radial in 1/6 scale.
Tom;

The thru hole on the one I have is .375. The shank has a .125 wall.

"Billy G"
Reply
Thanks given by:
Interesting tool. Frank Ford made something similar. His is designed to accommodate .500" but could be scaled up.
Hunting American dentists since 2015.
Reply
Thanks given by:
Thank you Darren. That one is less complicated to set and adjust.

"Billy G"
Reply
Thanks given by:
nice work on the distrubitors Bill!

DA
dallen, proud to be a member of MetalworkingFun Forum since Apr 2012.

If life seems normal, your not going fast enough! Tongue
Reply
Thanks given by:
Billy,
It really does look good. Very nice work Thumbsup Smiley-signs107
Smiley-eatdrink004
DaveH
Reply
Thanks given by:
Looking very nice Bill
DroolDroolDroolDroolDrool
John
Reply
Thanks given by:
    Time to make some major progress on this engine. 20 blanks 24 operations per blank. One operation is completed on all of the blanks before going to the next operation. I would like to complete this task in one week.

"Billy G"
Reply
Thanks given by:
It looks like the easy operation is done. At least it's 12L14 instead of nasty 1018.

Ed
Reply
Thanks given by:
Holy cow Bill, six spares? Let's hope you won't need that many. Yikes

Tom
[Image: TomsTechLogo-Profile.png]
Reply
Thanks given by:
This build changed to the Lee Hodgson 18 when so many things were fond wrong with the P&W. Everything was redone on the prints and we will finish that one after this one.. There is only 1 spare and 1 set-up piece. The other 18 have to be spot on.

"Billy G"
Reply
Thanks given by:




Users browsing this thread: 2 Guest(s)