P&W 1830 Radial in 1/6 scale.
#61
Pic #1 is the front 1/3. I did it last night. Pic #2 is the center in progress to fit to the front. Pic #3 is the mating of both parts. Done deal so far. Now to turn the center in the 4 jaw and proceed to fit the rear after it is made. I run out of time fast lately. LOL

"Billy G" Big Grin


Attached Files Thumbnail(s)
           
Reply
Thanks given by:
#62
Bill,
It's coming a longThumbsup
Smiley-eatdrink004
DaveH
Reply
Thanks given by:
#63
Bill,6820

this is a fun build, lot's of interesting bits and pieces along with some clever machining. Smiley-signs107Drool

Jerry.Popcorn
ETC57, proud to be a member of MetalworkingFun Forum since Feb 2012.
Reply
Thanks given by:
#64
Smiley-signs064

Ed
Reply
Thanks given by:
#65
EEEEYUP --- Turned it 180 in the 4 jaw and roughed the OD. Turned to finish bore depth. Now to turn the mounting flange for the rear piece. Turn it 180 again and turn finish OD.

"Billy G" Big Grin


Attached Files Thumbnail(s)
   
Reply
Thanks given by:
#66
Looking good Bill. I wonder if a swarf guard for the motor is in order?
Hunting American dentists since 2015.
Reply
Thanks given by:
#67
No trouble there yet Darren. but you are right, better now than after the fact.

"Billy G" Big Grin
Reply
Thanks given by:
#68
hi It's coming a long nice work
krv3000, proud to be a member of MetalworkingFun Forum since Feb 2012.
Reply
Thanks given by:
#69
Pic #1 mounting flange cut. Pic#2 yea, it fits tight. Pic#3 all three parts. Pic #4 they fit tight. Pic #5, mounted to the Turbo Case, again nice and tight.
Today will be taken up by drilling and tapping all the holes that hold these four units together. Then the finish OD on the crankcase can be dealt with.
Thanks for all the encouragement. This is a slow moving project and it's about to get slower. Big Grin

"Billy G" Smile


Attached Files Thumbnail(s)
                   
Reply
Thanks given by:
#70
Bill,
Might be slow but it is sure damn good to see and follow.
Some good machining skills Smiley-signs107
Smiley-eatdrink004
DaveH
Reply
Thanks given by:




Users browsing this thread: 3 Guest(s)