07-08-2012, 09:32 AM
Silly me on the use of the clamps... I have totally forgotten the existence of the step blocks till I was changing to my sleeping attire.
About the shield, you can see the big gap with the shield at the highest possible position.
![[Image: 26a53399-1.jpg]](http://i1207.photobucket.com/albums/bb469/wongstersproduction/26a53399-1.jpg)
This is with the spindle retracted.
I think an ER type of collet chuck, I would not have the problem not the shield getting in the way. The Proxxon Drill Press Vise is only a temporary solution used for the test cut. I'll still be getting a vise.
With the table size at 450mm x 180mm, any recommendation of the type of vise I should get?
Regards,
Wong
About the shield, you can see the big gap with the shield at the highest possible position.
This is with the spindle retracted.
I think an ER type of collet chuck, I would not have the problem not the shield getting in the way. The Proxxon Drill Press Vise is only a temporary solution used for the test cut. I'll still be getting a vise.
With the table size at 450mm x 180mm, any recommendation of the type of vise I should get?
Regards,
Wong
Wongster
http://www.wongstersproduction.com
Proud to be a member of MetalworkingFun Forum since Mar 2012.
http://www.wongstersproduction.com
Proud to be a member of MetalworkingFun Forum since Mar 2012.