Another puller
#1
I need to replace the bearings in the motor for my mill. The pulley was well and truly stuck onto the shaft and the motor diameter exceeded the limits of my press. So into the scrap bin, a couple of welds, the pressure screw (borrowed) from another puller and a few nuts, bolts and washers:

   
   
   
Hunting American dentists since 2015.
Reply
Thanks given by:
#2
Propper jobThumbsupThumbsupThumbsup
John
Reply
Thanks given by:
#3
Mayhem,

Well done Thumbsup Smiley-signs107
Smiley-eatdrink004
DaveH
Reply
Thanks given by:
#4
Thanks guys - one of the easier jobs I have done lately. I may have to get a bigger box to put my 'special' pullers in. One I have is about 1m long.
Hunting American dentists since 2015.
Reply
Thanks given by:
#5
Improvise, adapt, and overcome. Outstanding! Smiley-eatdrink004

Willie
Willie
Reply
Thanks given by:
#6
Well done,Thumbsup

Jerry.Popcorn
ETC57, proud to be a member of MetalworkingFun Forum since Feb 2012.
Reply
Thanks given by:
#7
Thanks guys.

For those of you who are still scared of your welder, the same result could have been achieved using angle iron for all the components.
Hunting American dentists since 2015.
Reply
Thanks given by:




Users browsing this thread: 1 Guest(s)