|
Spindle Tach
|
This is a few years ago (maybe 20) but Red Lion Controls used to sell a niftyLCD readout tac that would couple with a sensor easily mounted anywhere convenient on the spindle.
I installed one on my Hendey lathe. http://www.redlion.net/
Busy Bee 12-36 lathe, Busy Bee Mill drill, Busy Bee 4x6 bandsaw, Homemade 9x17 bandsaw, Ad infinitum.
|
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
Spindle Tach - by Bustednuklz - 08-11-2012, 06:41 PM
RE: Spindle Tach - by dallen - 08-11-2012, 07:48 PM
RE: Spindle Tach - by stevec - 08-11-2012, 08:43 PM
RE: Spindle Tach - by EdK - 08-11-2012, 08:46 PM
RE: Spindle Tach - by ScrapMetal - 08-11-2012, 10:55 PM
RE: Spindle Tach - by Highpower - 08-12-2012, 01:21 AM
RE: Spindle Tach - by EdK - 08-12-2012, 09:16 AM
RE: Spindle Tach - by Highpower - 08-11-2012, 09:54 PM
RE: Spindle Tach - by truckin23 - 08-11-2012, 11:16 PM
RE: Spindle Tach - by TOM REED - 08-12-2012, 03:15 AM
RE: Spindle Tach - by Rickabilly - 08-27-2012, 03:09 PM
RE: Spindle Tach - by TOM REED - 08-28-2012, 03:02 AM
RE: Spindle Tach - by Rickabilly - 08-28-2012, 04:03 AM
RE: Spindle Tach - by Highpower - 08-28-2012, 10:33 AM
RE: Spindle Tach - by EdK - 08-28-2012, 11:49 AM
RE: Spindle Tach - by Highpower - 08-28-2012, 12:35 PM
RE: Spindle Tach - by TOM REED - 08-29-2012, 10:11 PM
RE: Spindle Tach - by EdK - 08-30-2012, 06:01 AM
RE: Spindle Tach - by Rickabilly - 08-30-2012, 03:51 AM
RE: Spindle Tach - by Highpower - 08-30-2012, 09:35 AM
RE: Spindle Tach - by TOM REED - 08-30-2012, 10:36 AM
RE: Spindle Tach - by henryarnold - 10-23-2012, 10:21 PM
RE: Spindle Tach - by Highpower - 08-30-2012, 02:08 PM
RE: Spindle Tach - by EdK - 08-30-2012, 03:46 PM
|
