10-10-2012, 10:22 AM
(10-10-2012, 10:09 AM)TomG Wrote: Hmmm. Pretty much any compound should shine it up. Try polishing it wet with some 600 grit first to remove any machining marks, then buff. If it's a thermoplastic, you may need to lean on it a bit to generate some heat.
Tom
I tried a couple of compounds - one for aluminium and one for stainless - didn't do much
I've tried this "lean on it a bit" in the past - gets bluudy hot and melts if I'm not careful
Thought about Brasso - might give that a go.
I think it is about time someone made some stuff "Make your plastic bits shiny"
DaveH