11-07-2012, 11:43 AM
(11-07-2012, 09:56 AM)f350ca Wrote: Nicely done Ed, did you saw or mill them, what did you decide to use for wipers?
Thanks Greg.
I milled them. They were kind of a pain in the butt to mill because of the short flat at the apex of the 'V'. These are actually for another member, Kaoma. He's going to use the wipers that came with the lathe that had no plates, just screws holding the semi-rigid plastic wipers in place. The plate in the upper right of the picture is sitting on one of the wipers.
I'm making extras for my lathe since we have the same lathe. I bought some neoprene rubber in two different durometers, 50 & 60, that I'm going to try.
Ed