Not sure Tom. I still need to set up the drive gear and pin the shafts together. I also have a new hand wheel for it and need to mill the drive dogs for it on the back of the hub. The original hand crank for the mill has 7 dogs Vs. the 9 dog (Bridgeport) manual drive hub that came with the drive unit.
///Edit: I forgot about mounting the limit switches and rails too! ///
I hated that crank anyway because it is too long and smacks the Y-axis crank handle all the time. (Along with my knuckles.) The new hand wheel will be well out of the way.
While I'm into it this far, I want to do some work on the tapered gib for the knee too. Might as well fix it now rather than later. I foresee some hand scraping in my near future.
///Edit: I forgot about mounting the limit switches and rails too! ///
I hated that crank anyway because it is too long and smacks the Y-axis crank handle all the time. (Along with my knuckles.) The new hand wheel will be well out of the way.
While I'm into it this far, I want to do some work on the tapered gib for the knee too. Might as well fix it now rather than later. I foresee some hand scraping in my near future.
Willie