05-27-2013, 05:20 PM
yes the pressure screw will fit into the hole you see in the end, only it will screw in from the knob side. I am making it to use on clock movement so I doesn't have to be very big. its primary use will be to remove the hand from the center shaft of the movement.
I saw one on ebay and figured that I needed one without the cost and that I could make it better looking. It will be a couple days before I do anything else as I have my mill tired up with a part that I don't want to have to redo the setup on and can't finish it till I go to town and hopefully find a carbide drill or endmill the right diameter to cut thru the casehardening.
Any way it was fun to make and its was something that the doctors wouldn't get to po'ed at me about after having a heart attack on monday, don't want to mess up the stint that they put in.
I saw one on ebay and figured that I needed one without the cost and that I could make it better looking. It will be a couple days before I do anything else as I have my mill tired up with a part that I don't want to have to redo the setup on and can't finish it till I go to town and hopefully find a carbide drill or endmill the right diameter to cut thru the casehardening.
Any way it was fun to make and its was something that the doctors wouldn't get to po'ed at me about after having a heart attack on monday, don't want to mess up the stint that they put in.
dallen, proud to be a member of MetalworkingFun Forum since Apr 2012.
If life seems normal, your not going fast enough!
If life seems normal, your not going fast enough!