Todays Project - What did you do today?

[f350ca]

Here's a couple of shots from the shop I thought someone might find interesting.
Needed to tram the mill, here's the setup I use. An old outer bearing race about 4 inch in dis, looking for a bigger one but this works. They're ground to beter tolerance than I'll ever hope to achieve.



This is a unique drill press vice that was on a bench top drill at a yard sale. The clamp that holds it to the table allows the rod to slide as well as swing. You clamp the part in the jaws, (which have prisms for holding round stock flat or vertical) but the system allows you to move it around to line up on center marks. But the rod is fixed so the part can't spin if the bit grabs.