10-05-2013, 01:47 PM
This is what I'll be doing tomorrow.
A chap brought in a fibreglass fan shroud for the rad on a Jaguar. Wants about 1/2 in taken off the edge, its too thick. Wouldn't be easy to cut on the table saw due to the shape but could be clamped down to the milling table and do one edge at a time. Will an end mill cut fibreglass or would a slitting saw do better?
A chap brought in a fibreglass fan shroud for the rad on a Jaguar. Wants about 1/2 in taken off the edge, its too thick. Wouldn't be easy to cut on the table saw due to the shape but could be clamped down to the milling table and do one edge at a time. Will an end mill cut fibreglass or would a slitting saw do better?
Free advice is worth exactly what you payed for it.
Greg
Greg