12-22-2013, 08:55 PM
Ken,
It would be much easier to slot the keyway on the mill. Just grind a slotting tool the slightly less than the width of the keyway and mount it in a collet. Then you can move the table to center it up, feed it and offset it the required amount to accurately size the width of the keyway (easier than grinding it right to size)
Tom
It would be much easier to slot the keyway on the mill. Just grind a slotting tool the slightly less than the width of the keyway and mount it in a collet. Then you can move the table to center it up, feed it and offset it the required amount to accurately size the width of the keyway (easier than grinding it right to size)
Tom