02-16-2014, 07:36 AM
(02-15-2014, 08:54 PM)PixMan Wrote: It seems the cutting pressure with a .010" deep (per side) pass was a bit too much and it started slipping in the chuck. Because it was following the previous passes, the tool never left it's path so no damage there.
I'm having a little trouble understanding that the workpiece slipped in the chuck but the "tool never left it's path".
Good job on the snowblower repair/improvement.
Busy Bee 12-36 lathe, Busy Bee Mill drill, Busy Bee 4x6 bandsaw, Homemade 9x17 bandsaw, Ad infinitum.