Steve,
I had made a 52 second video of a single pass on the last attempt, when I was about halfway done. I didn't want to "jinx" it this time, just wanted to "Git 'er dun".
No fears about test fitting the screw all the way into the nut I'll make. I am quite confident that there's not more than .001" variation in thread pitch diameter.
I had made a 52 second video of a single pass on the last attempt, when I was about halfway done. I didn't want to "jinx" it this time, just wanted to "Git 'er dun".
No fears about test fitting the screw all the way into the nut I'll make. I am quite confident that there's not more than .001" variation in thread pitch diameter.