08-09-2014, 06:42 AM
Finally found the time to put the boards up in the section of my workshop where the lathe and mill will reside.
I still have some 3 phase and single phase wiring to do but that will have to wait until I can find a day where I can get off work a little earlier, as the distributor I use closes at 4pm.
Ignore the clutter on the bench and the temporary table covered with mess...
I still have some 3 phase and single phase wiring to do but that will have to wait until I can find a day where I can get off work a little earlier, as the distributor I use closes at 4pm.
Ignore the clutter on the bench and the temporary table covered with mess...
Hunting American dentists since 2015.