10-21-2014, 07:55 PM
(10-21-2014, 06:52 PM)TomG Wrote: It's coming along nicely David. I assume you couldn't reach the slot with a long end mill?
Tom
Drawing may explain it better then I can, but the center of the radius is inside the block so the only way to mill it would be to put it on a rotary table in a vertical position, anyway it would of probably taken me longer to rig it then to chip out the little bit that wasn't milled out in the flat position.
if you know of a better way I'm ready to hear it incase I have to do this again.
![[Image: block.png]](http://s1222.photobucket.com/user/Superdave257/media/block.png.html)
dallen, proud to be a member of MetalworkingFun Forum since Apr 2012.
If life seems normal, your not going fast enough!
If life seems normal, your not going fast enough!