10-23-2014, 07:02 PM
what I did today
after looking at the cost of sand paper I figure if I shorten the barrel to around 5 inches I can save a butt load of money and shorten the build time to about 1 month instead of half a year for all the sanding that long barrel will require.
Ok just joking who wants to shoot something with that short of a barrel chamber in something like a 45/120 anyway.
So new photos of work so far.
The boss in his office, you can tell he's working cause he's been cleaning his paws on my grease rag.
The better photo of the pipe and receiver laid out on the tailgate, damn things too long to get a decent close up
Marks left from the mill table being .5 inches too short
Marks removed
Work on the finger lever narrowing it down some
after looking at the cost of sand paper I figure if I shorten the barrel to around 5 inches I can save a butt load of money and shorten the build time to about 1 month instead of half a year for all the sanding that long barrel will require.
Ok just joking who wants to shoot something with that short of a barrel chamber in something like a 45/120 anyway.
So new photos of work so far.
The boss in his office, you can tell he's working cause he's been cleaning his paws on my grease rag.
The better photo of the pipe and receiver laid out on the tailgate, damn things too long to get a decent close up
Marks left from the mill table being .5 inches too short
Marks removed
Work on the finger lever narrowing it down some
dallen, proud to be a member of MetalworkingFun Forum since Apr 2012.
If life seems normal, your not going fast enough!
If life seems normal, your not going fast enough!