11-22-2014, 09:14 AM
(11-21-2014, 06:08 PM)TomG Wrote: You can solder the insulated ones Steve but it just takes a big iron or a torch so you can solder them quick before it makes a mess. I prefer to use the bare ones and insulate with shrink tubing if necessary, like I did on the controller for my anodizing bench.
Tom
trick to crimping the terminals is to throw the parts store crimper/strippers away and get yourself a damn good pair of Sta-Con crimpers made for the terminals that you use.
they make them for both insulated and uninsulated
I carried a pair like the ones in the photo for close to 20 years without wearing them out of the joint springing, still have em
DA
dallen, proud to be a member of MetalworkingFun Forum since Apr 2012.
If life seems normal, your not going fast enough!
If life seems normal, your not going fast enough!