Todays Project - What did you do today?

[dallen]

(11-24-2014, 10:13 PM)PixMan Wrote: David,

Would it be willing to post the drawing of the long thin sight leaf in your thread in Gunsmithing section? I'd like to get input from experienced guys like Tom, Arvid and others who may have faced a similar challenge. It's not the long thin part of it which I find myself scratching my head about, rather the junction of the Ø 0.310 round with the 1/4-40 thread where it meets the 0.150" wide blade.

I have several ideas but would like others to see it so we can bounce some ideas around the collective here.

naw post it where you think you need to, someone has to have an easy way to make the thing. Only way I could think of to make it was to silver solder a round bar onto the thin flat part then drill and thread it.

David