01-16-2015, 05:42 PM
Worked on cutting out some bad areas on the side panels of a snow thrower housing. The previous owner ran the thing for 18 years without ever replacing the scraper bar. The left half of the scraper and lower housing were completely ground away from rubbing on pavement, and then started dragging on the side plates resulting in several holes and rusted metal. I still need to cut out some patch panels and weld them in. What sux is they are all different gauges of metal. (16, 18 and 20 gauge.)
I would have liked to use my tig machine on these but I've got a bum leg/knee right now and can barely walk, so using a foot pedal is out.
Will have to go at it with the mig machine after changing over the wire - yet again....
I would have liked to use my tig machine on these but I've got a bum leg/knee right now and can barely walk, so using a foot pedal is out.
Will have to go at it with the mig machine after changing over the wire - yet again....
Willie