02-22-2015, 05:10 PM
Well
just got in from milling 2 tangential tool holders. interesting setting up for 12' in 2 dimensions. Now need to make a sharpening jig for the grinder and try it out!
Then decided to open out the slots on the "new" Boxford MD4 pillar drill table so I can use my existing hold down t nuts etc. Went well and didn't break a cutter today ( big improvement on last week when milling the slots for the tool bit in the holders- 2 cutters broken, both through over enthusiasm- live and learn).
Good luck with the car!
just got in from milling 2 tangential tool holders. interesting setting up for 12' in 2 dimensions. Now need to make a sharpening jig for the grinder and try it out!
Then decided to open out the slots on the "new" Boxford MD4 pillar drill table so I can use my existing hold down t nuts etc. Went well and didn't break a cutter today ( big improvement on last week when milling the slots for the tool bit in the holders- 2 cutters broken, both through over enthusiasm- live and learn).
Good luck with the car!