06-01-2015, 08:07 AM
(05-31-2015, 11:05 PM)TomG Wrote: I used a .376 reamer David. Don't know exactly what the fit is, but it feels pretty good.
Tom
first one I did I checked the selector and found that it was like 4 thousands under what the hole was suppose to be, so I always measure the selector then ream the hole for a slip fit. Another place to watch out for is the detent pin hole for the selector, don't know if its a problem with the measurement on the print I used or with the casting but had one selector that ended up with a bunch of sideways slop which I didn't like.
DA
dallen, proud to be a member of MetalworkingFun Forum since Apr 2012.
If life seems normal, your not going fast enough!
If life seems normal, your not going fast enough!