08-10-2015, 11:37 AM
(This post was last modified: 08-10-2015, 11:37 AM by Sunset Machine.)
Wish I had a big bandsaw. It would make shorter work of the job in the attached video, currently with a MRR of .17 cu in/min. I did this same job last year on a horizontal mill, but couldn't get enough coolant on the cutter. That was one one smoky, oily mess and I could only coax .25 cu in/min out of it. In contrast, this old clunk puts me to sleep...
Decided on the old gal at the last minute, you can probably tell it caught me short of a few clamps and had to improvise. Not recommended! Lean over and those tall studs sticking up will snag a shirt and pull a guy under the bridge.
Planer.avi (Size: 2.91 MB / Downloads: 18)
Decided on the old gal at the last minute, you can probably tell it caught me short of a few clamps and had to improvise. Not recommended! Lean over and those tall studs sticking up will snag a shirt and pull a guy under the bridge.
Planer.avi (Size: 2.91 MB / Downloads: 18)